Cisco SGE2000 - Cisco - Gigabit Switch - Modifying a Multicast Group

Configuring Multicast Forwarding
Defining Multicast Group
Cisco Small Business SFE/SGE Managed Switches Administration Guide 240
9
- Forbidden — Forbidden interfaces are not included the Multicast group,
even if IGMP Snooping designated the interface to join a Multicast
group.
- None — The interface is not part of a Multicast group.
STEP 2 Click the Add button. The Add Multicast Group Page opens:
Add Multicast Group Page
The
Add Multicast Group Page contains the following fields:
• VLAN ID — Displays the VLAN ID.
• Bridge Multicast IP Address — Displays the IP address attached to the
Multicast Group.
• Bridge Multicast MAC Address — Displays the MAC address attached to the
Multicast Group.
STEP 3 Define the relevant fields.
STEP 4 Click Apply. The Multicast Group is added, and the device is updated.
Modifying a Multicast Group
STEP 1 Click Bridging > Multicast> Multicast Groups. The Multicast Group Page opens:
STEP 2 Click the Edit button. The Edit Multicast Group Page opens.