Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring Device Security
Defining Dynamic ARP Inspection
Cisco Small Business SFE/SGE Managed Switches Administration Guide 142
4
NOTE ARP inspection is performed only on untrusted interfaces.
The ARP Inspection section contains the following topics:
• Defining ARP Inspection Properties
• Defining ARP Inspection Trusted Interfaces
• Defining ARP Inspection List
• Assigning ARP Inspection VLAN Settings
Defining ARP Inspection Properties
The ARP Inspection Properties Page provides parameters for enabling and setting
global Dynamic ARP Inspection parameters, as well as defining ARP Inspection
Log parameters.
To define ARP Inspection properties:

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x