Cisco SGE2000 - Cisco - Gigabit Switch - Enabling ARP Proxy (Layer 3)

Configuring IP Information
IP Addressing
Cisco Small Business SFE/SGE Managed Switches Administration Guide 209
7
STEP 3 Define the relevant fields.
STEP 4 Click Apply. The IP interface configuration is defined, and the device is updated.
Enabling ARP Proxy (Layer 3)
The Address Resolution Protocol (ARP) is a TCP/IP protocol that converts IP
addresses into physical addresses. The
ARP Proxy Page allows network
managers to enable ARP Proxy on the switch. This section is applicable to Layer 3
devices only.
STEP 1 Click System > System Management > IP Addressing > ARP Proxy. The ARP Proxy
Page
opens:
ARP Proxy Page
The
ARP Proxy Page contains the following field.
• ARP Proxy — Defines the ARP Proxy status. The possible values are:
- Enable — Enables the device to respond to ARP requests for located
nodes.
- Disable — The device responds with its own MAC address.
STEP 2 Select ARP Proxy.