Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring Device Security
Defining Dynamic ARP Inspection
Cisco Small Business SFE/SGE Managed Switches Administration Guide 146
4
Edit Interface Settings Page
STEP 3 Define the fields.
STEP 4 Click Apply. The Trusted Interface’s configuration is modified, and the device is
updated.
Defining ARP Inspection List
The ARP Inspection List Page provides information for creating static ARP Binding
Lists. ARP Binding Lists contain the List Name, IP address and MAC address which
are validated against ARP requests and replies.
To add an ARP Inspection List entry:

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x