EasyManuals Logo

Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Cisco SGE2000 - Cisco - Gigabit Switch
410 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #132 background imageLoading...
Page #132 background image
Configuring Device Security
Defining DoS Prevention
Cisco Small Business SFE/SGE Managed Switches Administration Guide 123
4
STEP 4 Click Apply. The ACL binding is defined, and the device is updated.
Defining DoS Prevention
Denial of Service
(DOS) increases network security by preventing packets with
invalid IP addresses from entering the network. DoS eliminates packets from
malicious networks which can compromise a network’s stability.
The device provides a Security Suite that allows administrators to match, discard,
and redirect packets based on packet header values. Packets which are
redirected are analyzed for viruses and Trojans.
DoS enables network managers to:
Deny packets that contain reserved IP addresses
Prevent TCP connections from a specific interface
Discard echo requests from a specific interface
Discard IP fragmented packets from a specific interface
The DoS Prevention section contains the following topics:
DoS Global Settings
Defining Martian Addresses
DoS Global Settings
The
Global Settings Page
allows network managers to enable and define global
DoS attack prevention parameters on the device. To open the
Global Settings
Page
:

Table of Contents

Other manuals for Cisco SGE2000 - Cisco - Gigabit Switch

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SGE2000 - Cisco - Gigabit Switch and is the answer not in the manual?

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General IconGeneral
Form FactorRack-mountable
Switching Capacity48 Gbps
Forwarding Rate35.7 Mpps
LayerLayer 2
Power SupplyInternal
ManagementWeb-based, SNMP, CLI
MAC Address Table Size8000 entries
VLANs256
FeaturesQuality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature0°C to 40°C (32°F to 104°F)
Storage Temperature-20 to 70°C (-4 to 158°F)
Relative Humidity10% to 90% non-condensing
Standards ComplianceIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x

Related product manuals