Cisco SGE2000 - Cisco - Gigabit Switch - Modifying GVRP Settings

Configuring VLANs
Defining GVRP Settings
Cisco Small Business SFE/SGE Managed Switches Administration Guide 174
6
• Copy From Entry Number — Copies GVRP parameters from the specified
table entry.
• To Entry Number(s) — Assigns the copied GVRP parameters to the specified
table entry.
• Ports of Unit — Indicates the port number and stacking member for which
GVRP parameters are displayed.
• LAGs — Indicates the LAG number for which GVRP parameters are displayed.
• Interface — Interface described by the GVRP settings entry.
• GVRP State — Indicates if GVRP is enabled on the interface. The possible field
values are:
- Enabled — Enables GVRP on the selected interface.
- Disabled — Disables GVRP on the selected interface.
• Dynamic VLAN Creation — Indicates if Dynamic VLAN creation is enabled on
the interface. The possible field values are:
- Enabled — Enables Dynamic VLAN creation on the interface.
- Disabled — Disables Dynamic VLAN creation on the interface.
• GVRP Registration — Indicates if VLAN registration through GVRP is enabled
on the device. The possible field values are:
- Enabled — Enables GVRP registration on the device.
- Disabled — Disables GVRP registration on the device.
STEP 2 Define the relevant fields.
STEP 3 Click Apply. The GVRP Settings are defined, and the device is updated.
Modifying GVRP Settings
STEP 1 Click Bridging > VLAN Management > GVRP Settings. The GVRP Settings Page
opens:
STEP 2 Click the Edit button. The Edit GVRP Page opens: