Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring IP Information
IP Addressing
Cisco Small Business SFE/SGE Managed Switches Administration Guide 190
7
Configuring IP Information
This section provides information for defining device IP addresses, and includes
the following topics:
• IP Addressing
• Layer 3 IP Addressing
• Domain Name System
IP Addressing
The IP Addressing section contains the topics:
• Managing IPv6
• Defining IPv4 Interface (Layer 2)
• Defining IPv4 Interface (Layer 3)
• Enabling ARP Proxy (Layer 3)
• Defining UDP Relay (Layer 3)
• Defining DHCP Relay (Layer 2)
• Defining DHCP Relay Interfaces
• Defining DHCP Relay (Layer 3)
• ARP
• Defining IP Routing
Managing IPv6
The Internet Protocol version 6 (IPv6) is a network layer protocol for packet-
switched internetworks. IPv6 was designed to eventually replace IPv4, the
predominantly deployed Internet protocol.

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x