EasyManuals Logo

Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Cisco SGE2000 - Cisco - Gigabit Switch
410 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #200 background imageLoading...
Page #200 background image
Configuring IP Information
IP Addressing
Cisco Small Business SFE/SGE Managed Switches Administration Guide 191
7
The main improvement IPv6 presents is address size, increasing from 32-bit to
128-bit addresses. The larger address size introduces greater flexibility in
assigning IP addresses.
IPv6 addresses are normally written as eight groups of four hexadecimal digits, for
example FE80:0000:9C00:876A:130B. The abbreviated form is also acceptable,
where a group of zeroes can be left out: FE80:9C0:876A:130B.
For IPv4-only nodes to communicate with IPv6 nodes, an intermediary transition
mechanism is required. The transition mechanism enables IPv6-only hosts to
reach IPv4 services and to allow isolated IPv6 hosts and networks to reach the
IPv6 Internet over the IPv4 infrastructure.
The tunneling mechanism implemented is ISATAP. This protocol treats the IPv4
network as a virtual IPv6 local link, with mappings from each IPv4 address to a link-
local IPv6 address.
The switch detects IPv6 frames by the IPv6 ether-type. The switch then can
assign the frame to a specific VLAN as defined by the user.
The IPv6 Configuration section contains the following topics:
Defining IPv6 Interface
Defining Default Gateway
Configuring ISATAP Tunnels
Viewing IPv6 Neighbors Information
Viewing IPv6 Routes Table
Defining IPv6 Interface
The IPv6 Interface Page provides parameters for defining IPv6 interfaces.
To d e f i n e I P v 6 i n t e r f a c e s :

Table of Contents

Other manuals for Cisco SGE2000 - Cisco - Gigabit Switch

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SGE2000 - Cisco - Gigabit Switch and is the answer not in the manual?

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General IconGeneral
Form FactorRack-mountable
Switching Capacity48 Gbps
Forwarding Rate35.7 Mpps
LayerLayer 2
Power SupplyInternal
ManagementWeb-based, SNMP, CLI
MAC Address Table Size8000 entries
VLANs256
FeaturesQuality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature0°C to 40°C (32°F to 104°F)
Storage Temperature-20 to 70°C (-4 to 158°F)
Relative Humidity10% to 90% non-condensing
Standards ComplianceIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x

Related product manuals