Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring SNMP
Configuring SNMP Security
Cisco Small Business SFE/SGE Managed Switches Administration Guide 314
12
- SNMPv3 — SNMPv3 is defined for the group.
• Security Level — Defines the security level attached to the group. Security
levels apply to SNMPv3 only.
- No Authentication — Neither the Authentication nor the Privacy security
levels are assigned to the group.
- Authentication — Authenticates SNMP messages, and ensures the
SNMP messages origin is authenticated.
- Privacy — Encrypts SNMP message.
• Operation — Defines the group access rights. The options for Read, Write, and
Notify operations are as follows:
- Default — Defines the default group access rights.
- DefaultSuper — Defines the default group access rights for
administrator.
STEP 3 Define the relevant fields.
STEP 4 Click Apply. The SNMP Group Profile is modified, and the device is updated.
Defining SNMP Communities
The Access rights are managed by defining communities in the SNMP
Communities Page
. When the community names are changed, access rights are
also changed. SNMP communities are defined only for SNMP v1 and SNMP v2c.
To define SNMP Communities:

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x