Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring Device Security
Defining DHCP Snooping
Cisco Small Business SFE/SGE Managed Switches Administration Guide 128
4
• Defining DHCP Snooping Properties
• Defining DHCP Snooping on VLANs
• Defining Trusted Interfaces
• Binding Addresses to the DHCP Snooping Database
• Defining IP Source Guard
Defining DHCP Snooping Properties
The DHCP Snooping Properties Page contains parameters for enabling DHCP
Snooping on the device.
To define the DHCP Snooping general properties:
STEP 1 Click Security Suite > DHCP Snooping > Properties. The DHCP Snooping
Properties Page
opens:
DHCP Snooping Properties Page
The
DHCP Snooping Properties Page contains the following fields:
• Enable DHCP Snooping — Indicates if DHCP Snooping is enabled on the
device. The possible field values are:
- Checked — Enables DHCP Snooping on the device.

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x