Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring Multicast Forwarding
Defining Multicast Group
Cisco Small Business SFE/SGE Managed Switches Administration Guide 241
9
Edit Multicast Group Page
The
Edit Multicast Group Page contains the following fields:
• VLAN ID — Displays the VLAN ID.
• Bridge IP Multicast — Displays the IP address attached to the Multicast Group.
• Bridge MAC Multicast — Displays the MAC address attached to the Multicast
Group.
• Interface — Displays the interface attached to the Multicast Group.
• Interface Status — Defines the interface status. The options are as follows:
- Static — Attaches the interface to the Multicast group as static member
in the Static Row. The interface has joined the Multicast group statically
in the Current Row.
- Forbidden — Forbidden interfaces are not included the Multicast group,
even if IGMP Snooping designated the interface to join a Multicast
group.
- None — The interface is not part of a Multicast group.
STEP 3 Change the Interface Status.
STEP 4 Click Apply. The Multicast Group parameters are saved, and the device is
updated.

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x