Cisco SGE2000 - Cisco - Gigabit Switch - Page 161

Configuring Ports
Configuring Ports Settings for Layer 2 Enabled Devices
Cisco Small Business SFE/SGE Managed Switches Administration Guide 152
5
STEP 1 Click Bridging > Port Management > Port Settings. The Port Settings Page opens:
Port Settings Page
The Port Settings Page
contains the following fields:
• Copy From Entry Number — Copies the port configuration from the specified
table entry.
• To Entry Number(s) — Assigns the copied port configuration to the specified
table entry.
• Unit Number — Indicates the stacking member for which the ports are defined.
• Interface — Displays the port number.
• Port Type — Displays the port type. The possible field values are:
- 1000M — Copper (copper cable).
- 1000M — ComboC (combo port with copper cable 3).
- 1000M — ComboF (combo port with optic fiber cable).
- Fiber — Indicates the port has a fiber optic port connection.
• Port Status — Displays the port connection status. The possible field values
are:
- Up — Port is connected.