Cisco SGE2000 - Cisco - Gigabit Switch - Page 259

Configuring Spanning Tree
Defining Spanning Tree
Cisco Small Business SFE/SGE Managed Switches Administration Guide 250
10
STEP 1 Click Bridging > Spanning Tree > Properties. The STP Properties Page opens:
STP Properties Page
The
STP Properties Page contains the following fields:
Global Settings
The Global Settings area contains device-level parameters.
• Spanning Tree State — Indicates if STP is enabled on the device. The possible
field values are:
- Enable — Enables STP on the device. This is the default value.
- Disable — Disables STP on the device.
• STP Operation Mode — Indicates the STP mode that is enabled on the device.
The possible field values are:
- Classic STP — Enables Classic STP on the device. This is the default
value.
- Rapid STP — Enables Rapid STP on the device.
- Multiple STP — Enables Multiple STP on the device.