Cisco SGE2000 - Cisco - Gigabit Switch - Page 266

Configuring Spanning Tree
Defining Spanning Tree
Cisco Small Business SFE/SGE Managed Switches Administration Guide 257
10
- Auto — Enables Port Fast mode a few seconds after the interface
becomes active.
• Enable Root Guard — Enable the prevention of a devices outside the network
core from being assigned the spanning tree root. The possible field values are:
- Checked — Enables Root Guard on the selected port or LAG.
- Unchecked — Disables Root Guard on the selected port or LAG. This is
the default value.
• Enable BPDU Guard — Protects the network from invalid configurations. The
possible field values are:
- Checked — Enables BPDU Guard on the selected port or LAG.
- Unchecked — Disables BPDU Guard on the selected port or LAG. This is
the default value.
• Port State — Displays the current STP state of a port. If enabled, the port state
determines what forwarding action is taken on traffic. Possible port states are:
- Disabled — Indicates that STP is currently disabled on the port. The port
forwards traffic while learning MAC addresses.
- Blocking — Indicates that the port is currently blocked and cannot
forward traffic or learn MAC addresses.
- Listening — Indicates that the port is in Listening mode. The port cannot
forward traffic nor can it learn MAC addresses.
- Learning — Indicates that the port is in Learning mode. The port cannot
forward traffic, however it can learn new MAC addresses.
- Forwarding — Indicates that the port is in Forwarding mode. The port
can forward traffic and learn new MAC addresses.
• Speed — Indicates the speed at which the port is operating.
• Path Cost — Defines the port contribution to the root path cost. The path cost
is adjusted to a higher or lower value, and is used to forward traffic when a path
being rerouted.
• Default Path Cost — Defines the default path cost as the Path Cost field
setting. The possible field values are:
- Checked — Path Cost is the default value.
- Unchecked — Path Cost is user-defined.