Cisco SGE2000 - Cisco - Gigabit Switch - Page 290

Configuring Quality of Service
Defining General Settings
Cisco Small Business SFE/SGE Managed Switches Administration Guide 281
11
- Rate Limit — Defines the rate limit for ingress ports. Defines the amount
of bandwidth assigned to the interface.
For FE ports, the rate is 62 - 100,000 Kbps.
For GE ports, the rate is 62 - 1,000,000 Kbps.
• Egress Shaping Rates — Indicates the traffic shaping type, if enabled, for
egress ports. The possible field values are:
- CIR — Defines Committed Information Rate ( CIR) as the queue shaping
type. The possible field values are:
For FE ports, the rate is 64 - 62,500 Kbps.
For GE ports, the rate is 64 - 1,000,000 Kbps.
- CbS — Defines Committed Burst Size (CbS) as the queue shaping type.
CbS is supported only on GE interfaces. The possible field value is 4096
- 16,769,020 bytes.
Modifying Bandwidth Settings
STEP 2 Click the Edit button. The Edit Bandwidth Page opens:
Edit Bandwidth Page
The
Edit Bandwidth Page contains the following fields:
• Interface — Indicates whether the interface, for which bandwidth settings are
edited, is a port or a LAG.
• Enable Egress Shaping Rate — Indicates if shaping is enabled on the interface.
The possible field values are:
- Checked — Enables egress shaping on the interface.
- Unchecked — Disables egress shaping on the interface.