Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Managing System Logs
Enabling System Logs
Cisco Small Business SFE/SGE Managed Switches Administration Guide 351
16
STEP 1 Click Admin > Logs > Logs Settings. The Log Settings Page opens.
Log Settings Page
The
Log Settings Page contains the following fields:
• Enable Logging — Indicates if message logging is enabled globally in the
device.
• Severity — The following are the available severity levels:
- Emergency —The system is not functioning.
- Alert — The system needs immediate attention.
- Critical — The system is in a critical state.
- Error — A system error has occurred.
- Warning — A system warning has occurred.
- Notice — The system is functioning properly, but system notice has
occurred.
- Informational — Provides device information.
- Debug — Provides detailed information about the log. If a Debug error
occurs, contact Customer Tech Support.

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x