EasyManuals Logo

Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Cisco SGE2000 - Cisco - Gigabit Switch
410 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #380 background imageLoading...
Page #380 background image
Viewing Statistics
Managing RMON Statistics
Cisco Small Business SFE/SGE Managed Switches Administration Guide 371
17
-
30 Sec
— Indicates that the RMON statistics are refreshed every 30
seconds.
-
60 Sec
— Indicates that the RMON statistics are refreshed every 60
seconds.
Received Bytes (Octets) — Displays the number of octets received on the
interface since the page was last refreshed. This number includes bad packets
and FCS octets, but excludes framing bits.
Dropped Events — Displays the number packets that were dropped.
Received Packets — Displays the number of packets received on the interface,
including bad packets, Multicast and broadcast packets, since the page was
last refreshed.
Broadcast Packets Received — Displays the number of good broadcast
packets received on the interface since the page was last refreshed. This
number does not include Multicast packets.
Multicast Packets Received — Displays the number of good Multicast packets
received on the interface since the page was last refreshed.
CRC & Align Errors — Displays the number of CRC and Align errors that have
occurred on the interface since the page was last refreshed.
Undersize Packets — Displays the number of undersized packets (less than 64
octets) received on the interface since the page was last refreshed.
Oversize PacketsDisplays the number of oversized packets (over 1518
octets) received on the interface since the page was last refreshed.
Fragments — Displays the number of fragments (packets with less than 64
octets, excluding framing bits, but including FCS octets) received on the
interface since the page was last refreshed.
Jabbers — Displays the total number of received packets that were longer
than 1518 octets. This number excludes frame bits, but includes FCS octets
that had either a bad Frame Check Sequence (FCS) with an integral number of
octets (FCS Error) or a bad FCS with a non-integral octet (Alignment Error)
number. The field range to detect jabbers is between 20 ms and 150 ms.
Collisions — Displays the number of collisions received on the interface since
the page was last refreshed.
Frames of xx Bytes — Number of frames containing the specified number of
bytes that were received on the interface since the page was last refreshed.

Table of Contents

Other manuals for Cisco SGE2000 - Cisco - Gigabit Switch

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SGE2000 - Cisco - Gigabit Switch and is the answer not in the manual?

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General IconGeneral
Form FactorRack-mountable
Switching Capacity48 Gbps
Forwarding Rate35.7 Mpps
LayerLayer 2
Power SupplyInternal
ManagementWeb-based, SNMP, CLI
MAC Address Table Size8000 entries
VLANs256
FeaturesQuality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature0°C to 40°C (32°F to 104°F)
Storage Temperature-20 to 70°C (-4 to 158°F)
Relative Humidity10% to 90% non-condensing
Standards ComplianceIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x

Related product manuals