Syslog Commands 403
Example
The following example limits logged messages sent to the syslog server with IP address 10.1.1.1 to
severity level critical.
logging console
The logging console Global Configuration mode command limits messages logged to the console based
on severity. Use the no form of this command to disable logging to the console.
Syntax
•
logging console
level
• no logging console
•
level
— Specifies the severity level of logged messages displayed on the console. Possible values:
emergencies, alerts
,
critical
,
errors, warnings
,
notifications, informational, debugging.
Default Configuration
The default severity level is informational.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example limits logging messages displayed on the console to severity level errors.
Console(config)# logging 10.1.1.1 severity critical
Console(config)# logging console errors
book.book Page 403 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
