308 QoS Commands
Default Configuration
Default CoS value of a port is 0.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode.
User Guidelines
• If the port is trusted, the default CoS value of the port is used to assign a CoS value to all untagged
packets entering the port.
Example
The following example configures port 1/e15 default CoS value to 3.
show qos map
The show qos map User EXEC mode command displays all QoS maps.
Syntax
•
show qos map
[
dscp-queue
]
•
dscp-queue
— Indicates the DSCP to queue map.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
User Guidelines
There are no user guidelines for this command.
Console(config)# interface ethernet 1/e15
Console(config-if) qos cos 3
book.book Page 308 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
