148 Configuration and Image Files
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• *.sys and *.prv files cannot be renamed.
Examples
The following example renames the configuration backup file.
boot system
The boot system Privileged EXEC mode command specifies the system image that the device loads at
startup.
Syntax
•
boot system
[
unit
unit
] {
image-1
|
image-2
}
•
unit
— Specifies the unit number.
•
image-1
— Specifies image 1 as the system startup image.
•
image-2
— Specifies image 2 as the system startup image.
Default Configuration
If the unit number is unspecified, the default setting is the master unit number.
Command Mode
Privileged EXEC mode.
User Guidelines
• Use the
show bootvar
command to find out which image is the active image.
Examples
The following example loads system image 1 at device startup.
Console# rename configuration.bak m-config.bak
Console# boot system image-1
book.book Page 148 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
