VLAN Commands 481
Example
The following example maps protocol ip-arp to the group named "213".
switchport general map protocols-group vlan
The switchport general map protocols-group vlan Interface Configuration mode command sets a
protocol-based classification rule. Use the no form of this command to delete a classification.
Syntax
•
switchport general map
protocols-group
group
vlan
vlan-id
•
no switchport general map
protocols-group
group
•
group
— Group number as defined in the
map protocol protocols-group
command. (Range: 1 -
2147483647)
•
vlan-id
— Define the VLAN ID in the classifying rule.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example sets a protocol-based classification rule of protocol group 1 to VLAN 8.
Console (config)# vlan database
Console (config-vlan)# map protocol ip-arp protocols-group 213
Console (config)# interface ethernet g8
console(config-if)# switchport general map protocols-group 1 vlan 8
book.book Page 481 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
