Dell PowerConnect 3524

260 LLDP Commands
• lldp med location ecs-elin data
• no lldp med location ecs-elin
• coordinate — The location is specified as coordinates
•
civic-address — The location is specified as civic address
•
ecs-elin — The location is specified as ECS ELIN
•
data — The data format is as defined in ANSI/TIA 1057. Specifies the location as dotted
hexadecimal data: Each byte in hexadecimal character strings is two hexadecimal digits. Each byte
can be separated by a period or colon.
Default Configuration
The location is not configured.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no guidelines for this command.
Example
The following example configures location information for the LLDP MED for an interface.
clear lldp rx
The clear lldp rx Privileged EXEC mode command restarts the LLDP RX state machine and clears the
neighbors table.
Syntax
• clear lldp rx [ ethernet interface ]
•
Interface — Ethernet port
console# config
console(config)# interface ethernet e6
console(config-if)# lldp med location civic-address
01:01:01:01:02:03
console(config-if)#
book.book Page 260 Thursday, December 18, 2008 7:40 PM