IP Addressing Commands 207
User Guidelines
There are no user guidelines for this command.
Example
The following example displays entries in the ARP table.
ip domain-lookup
The ip domain-lookup Global Configuration mode command enables the IP Domain Naming System
(DNS)-based host name-to-address translation. Use the no form of this command to disable DNS-based
host name-to-address translation.
Syntax
•
ip domain-lookup
• no ip domain-lookup
Default Configuration
IP Domain Naming System (DNS)-based host name-to-address translation is enabled.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following example enables IP Domain Naming System (DNS)-based host name-to-address
translation.
Console# show arp
ARP timeout: 80000 Seconds
Interface IP address HW address Status
--------- ---------- ----------------- -------
1/e1 10.7.1.102 00:10:B5:04:DB:4B Dynamic
2/e2 10.7.1.135 00:50:22:00:2A:A4 Static
Console(config)# ip domain-lookup
book.book Page 207 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
