182 Ethernet Configuration Commands
show ports storm-control
The show ports storm-control Privileged EXEC mode command displays the storm
control configuration.
Syntax
•
show ports storm-control
[
interface
]
•
interface —
A valid Ethernet port. (Full syntax:
unit/port
)
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the storm control configuration.
Console# show ports storm-control
Port State Rate
[Kbits/
Sec]
Included
---- -------- --------- ------------------------------.
1/e1 Disabled 3500 Broadcast
1/e2 Disabled 3500 Broadcast
1/e3 Disabled 3500 Broadcast
1/e4 Disabled 3500 Broadcast, Multicast
1/e5 Disabled 3500 Broadcast
1/e6 Disabled 3500 Broadcast
1/e7 Disabled 3500 Broadcast
1/e8 Disabled 3500 Broadcast
1/e9 Disabled 3500 Broadcast
book.book Page 182 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
