VLAN Commands 475
Default Configuration
If the port is added to a VLAN without specifying tagged or untagged, the default setting is tagged.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
This command enables changing the egress rule (e.g., from tagged to untagged) without first removing
the VLAN from the list.
Example
The following example adds VLANs 2, 5, and 6 to the allowed list of Ethernet port 1/e16 .
switchport general pvid
The switchport general pvid Interface Configuration mode command configures the PVID when the
interface is in general mode. Use the no form of this command to return to the default configuration.
Syntax
•
switchport general pvid
vlan-id
• no switchport general pvid
•
vlan-id
— Specifies the PVID (Port VLAN ID).
Default Configuration
If the default VLAN is enabled, PVID = 1. Otherwise, PVID=4095.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
There are no user guidelines for this command.
Console(config)# interface ethernet 1/e16
Console(config-if)# switchport general allowed vlan add 2,5-6
tagged
book.book Page 475 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
