348 SNMP Commands
snmp-server trap authentication
The snmp-server trap authentication Global Configuration mode command enables the device to send
SNMP traps when authentication fails. Use the no form of this command to disable SNMP failed
authentication traps.
Syntax
• snmp-server trap authentication
• no snmp-server trap authentication
Default Configuration
SNMP failed authentication traps are enabled.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following example enables SNMP failed authentication traps.
snmp-server contact
The snmp-server contact Global Configuration mode command configures the system contact
(sysContact) string. To remove system contact information, use the no form of the command.
Syntax
•
snmp-server contact
text
• no snmp-server contact
•
text
— Specifies the string that describes system contact information.
(Range: 0 - 160 characters)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
Console(config)# snmp-server trap authentication
book.book Page 348 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
