Dell PowerConnect 3524

QoS Commands 305
qos map dscp-queue
The qos map dscp-queue Global Configuration mode command modifies the DSCP to queue map. Use
the no form of this command to return to the default map.
Syntax
• qos map dscp-queue dscp-list to queue-id
• no qos map dscp-queue [ dscp-list ]
• dscp-list — Specify up to 8 DSCP values, separate each DSCP with a space. (Range: 0 - 63)
•
queue-id — Enter the queue number to which the DSCP value corresponds.
Default Configuration
The following table describes the default map.
Ethernet e2
wrr bandwidth weights and EF priority:
qid weights Ef Priority
1 N/A ena 1
2 N/A ena 2
3 N/A ena 3
4 N/A ena 4
Cos-queue map:
0 2
1 1
2 1
3 2
4 3
5 3
6 4
74
DSCP value 0-15 16-31 32-47 48-63
Queue-ID 12 3 4
book.book Page 305 Thursday, December 18, 2008 7:40 PM