426 System Management
Default Configuration
Disables forcing the selection of a stack master.
Command Mode
Global Configuration mode.
User Guidelines
• The following algorithm is used to select a unit as the master:
– If only one master-enabled unit is in the stack (1 or 2), it becomes the master.
– If a unit configured as a forced master, it becomes the master.
If a forced master unit is removed from a stack and placed in a different stack with another forced
master unit, both are considered to be forced, and the election criteria continue as follows:
– The unit with the longer up-time is elected master. Units are considered to have the same up-time
if they were powered up within ten minutes of each other.
– If both forced master units have the same up-time, Unit 1 is elected.
Example
The following example selects Unit 2 as the stack master.
stack reload
The stack reload Privileged EXEC mode command reloads stack members.
Syntax
•
stack reload
[
unit
]
•
unit —
Number of the unit to be reloaded (Range: 1 - 8)
Default Configuration
All units are reloaded.
Command Mode
Privileged EXEC mode.
User Guidelines
If no unit is specified, all units are reloaded.
Console(config)# stack master unit 2
book.book Page 426 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
