78 Command Modes
VC (VLAN Configuration) Mode
show rmon log Displays the RMON logging table.
show rmon statistics Displays RMON Ethernet Statistics.
show sessions Lists the open Telnet sessions.
show stack Displays information about stack status.
show system Displays system information.
show system id Displays the service id information.
show users Displays information about the active users.
show version Displays the system version information.
telnet Sends ICMP echo request packets to another node on the network.
terminal datadump Enables dumping all output of a show command without prompting.
terminal history Enables the command history function for the current terminal session.
terminal history size Configures the command history buffer size for the current
terminal session.
traceroute Discovers the routes that packets will actually take when traveling to
their destination.
traffic-shape Assigns CoS values to select one of the egress queues.
Command Group Description
bridge address Adds a static MAC-layer station source address to the bridge table.
bridge multicast address Registers MAC-layer Multicast addresses to the bridge table, and adds
static ports to the group.
bridge multicast forbidden
address
Forbids adding a specific Multicast address to specific ports.
bridge multicast forbidden
forward-all
Forbids a port from becoming a forward-all Multicast port.
bridge multicast forward-all Enables forwarding of all Multicast frames on a port.
dot1x auth-not-req Enables unauthorized users access to that VLAN.
ip igmp snooping (Interface) Enables Internet Group Management Protocol (IGMP) snooping on a
specific VLAN.
ip igmp snooping host-time-out Configures the host-time-out.
ip igmp snooping leave-time-out Configures the leave-time-out.
ip igmp snooping mrouter Enables automatic learning of Multicast router ports.
book.book Page 78 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
