Ethernet Configuration Commands 163
Ethernet Configuration Commands
interface ethernet
The interface ethernet Global Configuration mode command enters the interface configuration
mode to configure an Ethernet type interface.
Syntax
•
interface ethernet
interface
•
interface —
Valid Ethernet port. (Full syntax:
unit/port
)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example enables configuring Ethernet port 5/e18.
interface range ethernet
The interface range ethernet Global Configuration mode command configures multiple Ethernet
type interfaces at the same time.
Syntax
•
interface range ethernet
{
port-range
|
all
}
•
port-range —
List of valid ports. Where more than one port is listed, separate non-consecutive
ports with a comma and no spaces, use a hyphen to designate a range of ports.
•
all
— All Ethernet ports.
Console(config)# interface ethernet 5/e18
book.book Page 163 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
