Dell PowerConnect 3524

User Interface 461
User Interface
enable
The enable User EXEC mode command enters the Privileged EXEC mode.
Syntax
• enable [ privilege-level ]
•
privilege-level — Privilege level to enter the system. (Range: 1 - 15)
Default Configuration
The default privilege level is 15.
Command Mode
User EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example enters Privileged EXEC mode.
disable
The disable Privileged EXEC mode command returns to the User EXEC mode.
Syntax
• disable [ privilege-level ]
•
privilege-level — Privilege level to enter the system. (Range: 1 - 15)
Console> enable
enter password:
Console#
book.book Page 461 Thursday, December 18, 2008 7:40 PM