Dell PowerConnect 3524

194 IGMP Snooping Commands
Syntax
• ip igmp snooping mrouter-time-out time-out
• no ip igmp snooping mrouter-time-out
• time-out — Multicast router timeout in seconds (Range: 1 - 2147483647)
Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the Multicast router timeout to 200 seconds.
ip igmp snooping leave-time-out
The ip igmp snooping leave-time-out Interface Configuration (VLAN) mode command configures the
leave-time-out. If an IGMP report for a Multicast group was not received for a leave-time-out period
after an IGMP Leave was received from a specific port, this port is deleted from the member list of that
Multicast group. Use the no form of this command to return to the default configuration.
Syntax
• ip igmp snooping leave-time-out { time-out | immediate-leave }
• no ip igmp snooping leave-time-out
• time-out — Specifies the leave-time-out in seconds for IGMP queries.
(Range: 0 - 2147483647)
•
immediate-leave — Indicates that the port should be immediately removed from the members list
after receiving IGMP Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Console(config)# interface vlan 2
Console(config-if)# ip igmp snooping mrouter-time-out 200
book.book Page 194 Thursday, December 18, 2008 7:40 PM