QoS Commands 307
Example
The following example configures the system to the DSCP trust state.
qos trust (Interface)
The qos trust Interface Configuration (Ethernet, Port-channel) mode command enables a port to be in
the trust state while the system is in the basic QoS mode. Use the no form of this command to disable
the trust state on a port.
Syntax
• qos trust
• no qos trust
Default Configuration
qos trust is enabled on each port.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example configures Ethernet port 1/e15 to the default trust state.
qos cos
The qos cos Interface Configuration (Ethernet, Port-channel) mode command defines the default CoS
value of a port. Use the no form of this command to return to the default configuration.
Syntax
•
qos cos
default-cos
• no qos cos
•
default-cos
— Specifies the default CoS value of the port. (Range: 0 - 7)
Console(config)# qos trust dscp
console(config)# interface ethernet 1/e15
console(config-if) qos trust
book.book Page 307 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
