256 LLDP Commands
Default Configuration
No optional TLV is transmitted.
Command Modes
Interface configuration (Ethernet)
User Guidelines
• There are no user guidelines for this command.
Example
The following example specifies which optional TLV (2)s from the basic set should be transmitted.
lldp management-address
The lldp management-address Interface Configuration mode command specifies the management
address advertised from an interface. Use the no form of this command to cease advertising management
address information.
Syntax
•
lldp management-address ip
ip-address
• no management-address ip
•
ip-address
—
Specifies the management address to advertise.
Default Configuration
No IP address is advertised.
Command Modes
Interface configuration (Ethernet) mode.
User Guidelines
• Each port can advertise one IP address.
• Only static IP addresses can be advertised.
Console(config)# interface ethernet g1
Console(config-if)# lldp optional-tlv sys-name
book.book Page 256 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
