Dell PowerConnect 3524

TACACS+ Commands 437
tacacs-server timeout
The tacacs-server timeout Global Configuration mode command sets the interval during which the
device waits for a TACACS+ server to reply. Use the no form of this command to return to the default
configuration.
Syntax
• tacacs-server timeout timeout
• no tacacs-server timeout
• timeout — Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
5 seconds.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following example sets the timeout value to 30.
tacacs-server source-ip
The tacacs-server source-ip Global Configuration mode command configures the source IP address to be
used for communication with TACACS+ servers. Use the no form of this command to return to the
default configuration.
Syntax
• tacacs-server source-ip source
• no tacacs-server source-ip source
• source — Specifies the source IP address.
Default Configuration
The source IP address is the address of the outgoing IP interface.
Console(config)# tacacs-server timeout 30
book.book Page 437 Thursday, December 18, 2008 7:40 PM