344 SNMP Commands
Syntax
•
snmp-server filter
filter-name oid-tree
{
included | excluded
}
•
no snmp-server filter
filter-name
[
oid-tree
]
•
filter-name
— Specifies the label for the filter record that is being updated or created. The name is
used to reference the record. (Range: 1 - 30 characters)
•
oid-tree
— Specifies the object identifier of the ASN.1 subtree to be included or excluded from the
view. To identify the subtree, specify a text string consisting of numbers, such as 1.3.6.2.4, or a
word, such as system. Replace a single sub identifier with the asterisk (*) wildcard to specify a
subtree family; for example, 1.3.*.4. You may also identify the subtree by specifying its logical
name; for example, "IfEntry.*.1".
•
included
— Indicates that the filter type is included.
•
excluded
— Indicates that the filter type is excluded.
Default Configuration
No filter entry exists.
Command Mode
Global Configuration mode.
User Guidelines
This command can be entered multiple times for the same filter record. Later lines take precedence
when an object identifier is included in two or more lines.
Examples
The following example creates a filter that includes all objects in the MIB-II system group except for
sysServices (System 7) and all objects for interface 1 in the MIB-II interfaces group.
snmp-server host
The snmp-server host Global Configuration mode command specifies the recipient of Simple Network
Management Protocol Version 1 or Version 2 notifications. Use the no form of this command to remove
the specified host.
Console(config)# snmp-server filter filter-name system included
Console(config)# snmp-server filter filter-name system.7 excluded
Console(config)# snmp-server filter filter-name ifEntry.*.1
included
book.book Page 344 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
