196 IGMP Snooping Commands
• Following are the IGMP Snooping Querier parameters as function of the IGMP Snooping parameters:
• QueryMaxResponseTime: host-time-out/15.
• QueryInterval: host-time-out/ 3.
Example
The following example enables IGMP querier on VLAN 2.
ip igmp snooping querier address
The ip igmp snooping querier address Interface Configuration mode command defines the source IP
address used by the IGMP Snooping querier. Use the no form of this command to return to default.
Syntax
• ip igmp snooping querier address ip-address
• no ip igmp snooping querier address
Default Configuration
If an IP address is configured for the VLAN, it is used as the source address of the IGMP snooping
querier.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
• If an IP address is not configured by this command, and no IP address is configured for the IGMP
querier VLAN interface, the qurier is disabled.
console# config
console(config)# interface vlan 2
VLAN 2 does not exist.
All settings will be applied to VLAN 2 when it is created.
console(config-if-ghost-vlan)# ip igmp snooping querier enable
console(config-if-ghost-vlan)#
book.book Page 196 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
