Dell PowerConnect 3524

254 LLDP Commands
Examples
The following example specifies how often the software sends Link Layer Discovery Protocol (LLDP)
updates.
lldp reinit-delay
The lldp reinit-delay Global Configuration mode command specifies the minimum time an LLDP port
waits before reinitializing LLDP transmission. Use the no form of this command to revert to the default
setting.
Syntax
• lldp reinit-delay seconds
•
no l ldp reinit-delay
•
seconds — Specifies the minimum time in seconds an LLDP port waits before reinitializing LLDP
transmission. (Range 1-10 seconds)
Default Configuration
2 seconds
Command Modes
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Examples
The following example specifies the minimum time an LLDP port will wait before reinitializing LLDP
transmission.
Console (config) # lldp hold-multiplier 6
Console (config) # lldp reinit-delay 6
book.book Page 254 Thursday, December 18, 2008 7:40 PM