Ethernet Configuration Commands 171
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• This command is used to activate interfaces that were configured to be active, but were shutdown by
the system for some reason (for example
port security
.
Example
The following example reactivates interface 1/e5.
show interfaces advertise
The show interfaces advertise Privileged EXEC mode command displays autonegotiation data.
Syntax
•
show interfaces advertise [ethernet
interface
|
port-channel
port-channel-number
]
•
interface
— Valid Ethernet port. (Full syntax:
unit/port
)
•
port-channel-number
— Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Console# set interface active ethernet 1/e5
book.book Page 171 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
