84 AAA Commands
Syntax
•
login authentication
{
default
|
list-name
}
• no login authentication
•
default
— Uses the default list created with the
aaa authentication login
command.
•
list-name
— Uses the indicated list created with the
aaa authentication login
command.
Default Configuration
Uses the default set with the command aaa authentication login.
Command Mode
Line Configuration mode.
User Guidelines
• Changing login authentication from default to another value may disconnect the telnet session.
Example
The following example specifies the default authentication method for a console.
enable authentication
The enable authentication Line Configuration mode command specifies the authentication method list
when accessing a higher privilege level from a remote telnet or console. Use the no form of this
command to return to the default configuration specified by the aaa authentication enable command.
Syntax
•
enable authentication
{
default
|
list-name
}
• no enable authentication
•
default
— Uses the default list created with the
aaa authentication enable
command.
•
list-name
— Uses the indicated list created with the
aaa authentication enable
command.
Default Configuration
Uses the default set with the aaa authentication enable command.
Command Mode
Line Configuration mode.
Console(config)# line console
Console(config-line)# login authentication default
book.book Page 84 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
