Dell PowerConnect 3524

Address Table Commands 115
Example
The following example displays the number of addresses present in all VLANs.
show bridge multicast address-table
The show bridge multicast address-table Privileged EXEC mode command displays Multicast
MAC address or IP Address Table information.
Syntax
• show bridge multicast address-table [ vlan vlan-id ] [ address mac-multicast-address | ip-multicast-
address
] [ format ip | format mac ]
•
vlan-id — A valid VLAN ID value.
•
mac-multicast-address — A valid MAC Multicast address.
•
ip-multicast-address — A valid IP Multicast address.
•
format ip|mac — Multicast address format. Can be ip or mac . If the format is unspecified, the
default is
mac .
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• A MAC address can be displayed in IP format only if it is in the range of 0100.5e00.0000-0100.5e7f.ffff.
Console# show bridge address-table count
Capacity: 8192
Free: 8083
Used: 109
Secure addresses: 2
Static addresses: 1
Dynamic addresses: 97
Internal addresses: 9
book.book Page 115 Thursday, December 18, 2008 7:40 PM