Dell PowerConnect 3524

314 RADIUS Commands
radius-server source-ip
The radius-server source-ip Global Configuration mode command specifies the source IP address used
for communication with RADIUS servers. Use the no form of this command to return to the default
configuration.
Syntax
• radius-server source-ip source
• no radius-source-ip source
• source — Specifies a valid source IP address.
Default Configuration
The source IP address is the IP address of the outgoing IP interface.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the source IP address used for communication with RADIUS servers
to 10.1.1.1.
radius-server source-ipv6
The radius-server source-ipv6 Global Configuration mode command specifies the source IPv6 address
used for the IPv6 communication with RADIUS servers. Use the no form of this command to return to
the default.
Syntax
• radius-server source-ipv6 source
• no radius-server source-ipv6 source
• source — Specifies the source IPv6 address.
console(config)# radius-server source-ip 10.1.1.1
book.book Page 314 Thursday, December 18, 2008 7:40 PM