180 Ethernet Configuration Commands
Command Modes
Interface Configuration (Ethernet) mode.
User Guidelines
• To control Multicasts storms, use the
port storm-control broadcast enable
and
port storm-control
broadcast rate
commands.
Example
The following example enables counting Broadcast and Multicast packets on Ethernet port 2/e3.
port storm-control broadcast enable
The port storm-control broadcast enable Interface Configuration (Ethernet) mode command enables
Broadcast storm control. Use the no form of this command to disable Broadcast storm control.
Syntax
• port storm-control broadcast enable
• no port storm-control broadcast enable
Default Configuration
Broadcast storm control is disabled.
Command Modes
Interface Configuration (Ethernet) mode.
User Guidelines
• Use the
port storm-control broadcast rate
Interface Configuration (Ethernet) mode command, to set
the maximum allowable Broadcast rate.
• Use the
port storm-control include-multicast
Interface Configuration (Ethernet) mode command to
count Multicast packets in the storm control calculation.
• The command can be enabled on specific port only if
rate-limit
interface configuration command is
not enabled on that port.
Console(config)# interface ethernet 2/e3
Console(config-if)# port storm-control include-multicast
book.book Page 180 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
