Dell PowerConnect 3524

Command Groups 45
Line Commands
LLDP Commands
Command Group Description Access Mode
line Identifies a specific line for configuration and enters
the Line Configuration command mode.
Global Configuration
speed Sets the line baud rate. Line Configuration
autobaud Sets the line for automatic baud rate detection. Line Configuration
exec-timeout Configures the interval that the system waits until
user input is detected.
Line Configuration
show line Displays line parameters. User EXEC
terminal history Enables the command history function for the
current terminal session.
User EXEC
terminal history size Cand history buffer size for the current terminal
session.
User EXEC
Command Group Description Access Mode
lldp enable (global) Enables Link Layer Discovery Protocol (LLDP). Global configuration
lldp enable (interface) Enables LLDP on an interface. Interface configuration
(Ethernet)
lldp timer Specifies how often the software sends LLDP updates. Global configuration
lldp hold-multiplier Specifies the amount of time the receiving device should
hold a LLDP packet before discarding it.
Global configuration
lldp reinit-delay Specifies the minimum time an LLDP port will wait
before reinitializing LLDP transmission.
Global configuration
lldp tx-delay Specifies the delay between successive LLDP frame
transmissions initiated by value/status changes in the
LLDP local systems MIB.
Global configuration
lldp optional-tlv Specifies which optional TLVs from the basic set should
be transmitted.
Interface configuration
(Ethernet)
lldp management-
address
Specifies the management address that would be
advertised from an interface.
Interface configuration
(Ethernet)
lldp med enable Enables LLDP Media Endpoint Discovery (MED) on an
interface.
Interface configuration
(Ethernet)
lldp med network-
policy (global)
Defines LLDP MED network policy. Global configuration
book.book Page 45 Thursday, December 18, 2008 7:40 PM