RADIUS Commands 315
Default Configuration
The default IP address is the outgoing IP interface.
Command Mode
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the source IPv6 address used for communication with RADIUS
servers.
radius-server timeout
The radius-server timeout Global Configuration mode command sets the interval during which the
device waits for a server host to reply. Use the no form of this command to return to the default
configuration.
Syntax
•
radius-server timeout
timeout
• no radius-server timeout
•
timeout
— Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
The timeout value is 3 seconds.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the timeout interval to 5 seconds.
Console (config)# radius-server source-ipv6 3156::98
Console(config)# radius-server timeout 5
book.book Page 315 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
