Dell PowerConnect 3524

Clock 133
Syntax
• sntp client enable { ethernet interface-number | vlan vlan-id | port-channel number }
•
no sntp client enable { ethernet interface-number | vlan vlan-id | port-channel number }
•
ethernet interface-number — Ethernet port number.
•
vlan vlan-id — VLAN number.
•
port-channel number — Port channel number.
Default Configuration
Disabled.
Command Mode
Global Configuration mode.
User Guidelines
• Use the sntp Broadcast client enable Global configuration command to enable Broadcast clients
globally.
• Use the
sntp Anycast client enable Global configuration command to enable Anycast clients globally.
Examples
The following example enables the SNTP client on the interface.
sntp client enable (Interface)
The sntp client enable Interface Configuration (Ethernet, port-channel, VLAN) mode command
enables the Simple Network Time Protocol (SNTP) client on an interface. This applies to both receive
Broadcast and Anycast updates. Use the no form of this command to disable the SNTP client.
Syntax
• sntp client enable
• no sntp client enable
Default Configuration
The SNTP client is disabled on an interface.
Command Mode
Interface configuration (Ethernet, port-channel, VLAN) mode.
Console (config)# sntp client enable
book.book Page 133 Thursday, December 18, 2008 7:40 PM