Command Groups 51
Spanning Tree Commands
snmp-server filter Creates and modifies filter entries. Global
Configuration
snmp-server host Specifies an SNMP notification recipient. Global
Configuration
snmp-server v3-host Specifies an SNMP v3 notification recipient. Global
Configuration
snmp-server trap
authentication
Enables the device to send Simple Network
Management Protocol traps when authentication
failed.
Global
Configuration
snmp-server contact Sets up a system contact. Global
Configuration
snmp-server location Sets up the information on where the device is
located.
Global
Configuration
snmp-server set Sets SNMP MIB value by the CLI. Global
Configuration
show snmp Displays the SNMP status. Privileged EXEC
show snmp engineid Displays the local SNMP EngineID. Privileged EXEC
show snmp views Displays the configuration of SNMP views. Privileged EXEC
show snmp groups Displays the configuration of SNMP groups. Privileged EXEC
show snmp filters Displays the configuration of SNMP filters. Privileged EXEC
show snmp users Displays the configuration of SNMP users. Privileged EXEC
Command Group Description Access Mode
spanning-tree Enables Spanning Tree functionality. Global Configuration
spanning-tree mode Configures the Spanning Tree protocol. Global Configuration
spanning-tree forward-
time
Configures the Spanning Tree bridge forward time. Global Configuration
spanning-tree hello-
time
Configures the Spanning Tree bridge Hello Time. Global Configuration
spanning-tree max-age Configures the Spanning Tree bridge maximum age. Global Configuration
spanning-tree priority Configures the Spanning Tree priority. Global Configuration
spanning-tree disable Disables Spanning Tree on a specific port. Interface Configuration
spanning-tree cost Configures the Spanning Tree path cost for a port. Interface Configuration
book.book Page 51 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
