Dell PowerConnect 3524

312 RADIUS Commands
Default Configuration
No RADIUS server host is specified.
The port number for authentication requests is 1812.
The usage type is all.
Command Mode
Global Configuration mode.
User Guidelines
• To specify multiple hosts, multiple radius-server host commands can be used.
• If no host-specific timeout, retries, deadtime or key-string values are specified, global values apply to
each RADIUS server host.
• The address type of the source parameter must be the same as the
ip-address parameter.
Example
The following example specifies a RADIUS server host with IP address 192.168.10.1, authentication
request port number 20 and a 20-second timeout period.
radius-server key
The radius-server key Global Configuration mode command sets the authentication and encryption key
for all RADIUS communications between the device and the RADIUS daemon. Use the no form of this
command to return to the default configuration.
Syntax
• radius-server key [ key-string ]
• no radius-server key
• key-string — Specifies the authentication and encryption key for all RADIUS communications
between the device and the RADIUS server. This key must match the encryption key used on the
RADIUS daemon. (Range: 0 - 128 characters)
Default Configuration
The key-string is an empty string.
Command Mode
Global Configuration mode.
Console(config)# radius-server host 192.168.10.1 auth-port 20
timeout 20
book.book Page 312 Thursday, December 18, 2008 7:40 PM