Dell PowerConnect 3524

System Management 427
Example
The following example reloads Unit 2 of the stack.
show stack
The show stack User EXEC mode command displays information about the status of a stack.
Syntax
• show stack [ unit unit ]
•
unit — Specifies the number of the unit. (Range: 1 - 6)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example displays stack status.
Console(config)# stack reload unit 2
Console> show stack
Unit MAC Address Software Master Uplink Downlink Status
---- -------------- -------- ------- ------ -------- ------
1 00:33:97:02:16:00 1.0.0.7 Forced 8 2 Master
2 00:33:97:02:21:00 1.0.0.7 Enabled 1 3 backup
3 00:33:97:02:12:00 1.0.0.7 Disabled 2 4 Slave
4 00:33:97:02:18:00 1.0.0.6 Disabled 3 5 Slave
5 00:33:97:02:14:00 1.0.0.7 Disabled 4 6 Slave
6 00:33:97:02:22:00 1.0.0.7 Disabled 5 7 Slave
7 00:33:97:02:11:00 1.0.0.7 Disabled 8 6 Slave
8 00:33:97:02:19:00 1.0.0.7 Disabled 7 1 Slave
book.book Page 427 Thursday, December 18, 2008 7:40 PM