IGMP Snooping Commands 197
Example
The following example enables IGMP querier on a specific VLAN.
show ip igmp snooping mrouter
The show ip igmp snooping mrouter User EXEC mode command displays information on dynamically
learned Multicast router interfaces.
Syntax
•
show ip igmp snooping mrouter
[
interface
vlan-id
]
•
vlan-id —
VLAN number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
User Guidelines
There are no user guidelines for this command.
console(config)# interface vlan 2
VLAN 2 does not exist.
All settings will be applied to VLAN 2 when it is created.
console(config-if-ghost-vlan)# ip igmp snooping querier enable
console(config-if-ghost-vlan)# ip igmp snooping querier address
% missing mandatory parameter
console(config-if-ghost-vlan)# ip igmp snooping querier address
1.1.1.1
console(config-if-ghost-vlan)#
book.book Page 197 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
